download
1) The “blue” colored screw in the image is the duration adjustment screw. Underneath the head of the screw is a lock nut and the bracket arm that the screw is threaded into. To decrease the amount of fuel squirted the adjustment screw is turned “clockwise” or in. To increase the amount of fuel squirted the adjustment screw is turned “counter clockwise” or out. To get the max, amount of decrease remove the screw and take the lock nut off of the screw. Then replace the screw into the cam arm, then replace the lock nut underneath the arm on the screw. this gives you another 3/32″ of an inch in which the screw can be screwed in.
2) Turn the adjustment screw fully clockwise or IN. Start your engine, Blip your throttle open, if the engine stutters, (hesitates), it is not getting enough fuel so turn the screw counter clockwise to increase the amount of fuel squirted from the accelerator pump into the carburetor. Keep blipping the throttle and adjusting the screw till the carburetor starts to cough. Stop here and turn the screw back in till the coughing stops. Tighten down the lock nut. This should give you the best throttle response with the least amount of coughing and backfiring out the carburetor. Timing Adjustment Screw This is the “Green” colored screw just above the Blue duration adjustment screw. The” Mucker” said it best,,,,, This upper screw adjusts the “timing” of the squirt. By altering it’s setting, you can advance or delay the onset of the fuel squirt. But probably, it won’t have to be touched
Incoming search terms:
- keihin vb #15a pilot screw adjustment
- fazer 600 2003 mixture setting
- what causes carburetor back fire on high rpm kawasaki atv 2004 prairie 360 4x4 help
- ninja 250 carburator specifications
- Mikuni Carburetor Air Screw Adjustment
- Mikuni Carb Air Screw Adjustment
- mikuni bs32ss
- tw200 pilot screw
- 1996 virago 535 ilde mixture screw and pilot air screw
- how to adjust carberuter back fire when you press thoutle 2004 Kawasaki Prairie 360 4X4 ATV